Objects For Scene Control - Theben DALI gateway S64 KNX User Manual

8.5.2 ECG objects – analysis and service
525 ECG 1, Failure Status
Sends the failure status of lamp, ECG and converter failures.
525a ECG 1, Failure Status
Note: This object is a NON DPT type and will not be implemented in future versions
Sends the failure status of lamp, ECG and converter failures.
526 ECG 1, Operating Hours Reset
Resets the operating hours counter.
ECG 1, Operating Hours
The operating hours of a lamp are sent via this object. The internal counter can be set to 0
(Reset) or another value via this object. Please remember: The "Write" flag is switched off in
the presetting.
528 ECG 1, Life Time Exceeded
This object is used to send a status message when the configured lifetime of a lamp is
exceeded.
8.6

Objects for scene control

The scene objects are collected in the scene channel.
Obj Object name
11 Scene invoke/
program
This object is used to invoke or program scenes. Up to 16 scenes are available on the DALI
gateway. To program a selected scene, you need to set the top Bit:
Scene 1
Scene 2
.............
Scene 15
Scene 16
39 Scene1, Dimming
Manual DALI gateway S64 KNX/S128 KNX
Function
Start Program
0 128
1 129
14 142
15 143
Brighter/Darker
Status
Status
Yes/No
Value
Yes/No
Type
Scene No. 8 Bit
18.001
4 Bit
3.007
ETS communication objects
1 Bit CRT
1.005
1 Byte CRT
5.0.10
1 Bit CW
1.015
4 Bytes CRT
13.100
1 Bit CRT
1.002
Flags
CW
CW
37