Parameter Configuration - Theben DALI gateway S64 KNX User Manual

Installation and commissioning concept
A file box will appear to select the ETS App for the DALI gateway KNX:
The application is displayed in the list of all ETS5 apps.
1000
When the product is selected an additional DCA tab is shown:
Then the ETS must be started again.
3.3

Parameter configuration

The parameters and the corresponding group addresses can then be configured as with any
other KNX product. With the help of the parameters, various operating modes can also be
configured, which are described in more detail in the chapter 5 Manual Mode.
The DALI specific configuration is performed in the DCA tab. First, the assignment of the ECGs to
the desired groups should be carried out.
This work can be carried out offline without connection to the KNX, or without connection to the
DALI gateway KNX. The actual DALI commissioning is only possible online, that means a
connection to the device is necessary. In this step, all connected ECGs are searched and found
and can then be assigned to the preconfigured configuration.
After this assignment has been carried out, this special DALI configuration must be loaded into
the device. The "Download" key is available in the DCA tab, see chapter 11 DALI commissioning.
In the last step, the parameters and the links to the group addresses should be loaded into the
device using normal ETS download. The device is now ready for operation.
Manual DALI gateway S64 KNX/S128 KNX 10