Table 10-17 Settings Of Sweep Switches - HP 8560E Service Manual

Synthesizer Section
Frequency Span Accuracy Problems
Table 10-17 Settings of Sweep Switches
Switch
U318A
U318B
U318C
U318D
7. Set the HP 8560E/EC to the following settings:
558
Switch State
Closed
Open
Closed
Open
Center frequency ..................................................... 300 MHz
Span ................................................................................. 0 Hz
Trigger ............................................................ SINGLE, EXT
a. On the HP 8560E/EC, press
b. Remove jumper A14J23 and connect a dc voltage source to
A14J23 pin 2. Connect the voltage source ground to A14J23 pin 3.
c. Connect a microwave frequency counter or spectrum analyzer to
the HP 8560E/EC 1ST LO OUTPUT (front panel output).
d. Set the dc voltage source output for 0 Vdc and note the 1st LO
frequency.
e. Set the dc voltage source output for +10 Vdc. The first LO
frequency should momentarily increase approximately
+15.6 MHz.
f. The voltage at A14U332 pin 2 should be approximately 19% of
the voltage at A14J23 pin 2.
g. If the first LO frequency did not change in step e, turn off the HP
8560E/EC switch and disconnect W10 from A14J3.
LINE
h. Place a jumper between A14J3 pins 9 and 10. Place a 50 Ω, 3 watt
resistor across A14J3 pins 5 and 6 (resistor, HP part number
0811-1086). Set the
i. On the HP 8560E/EC, press
j. The voltage at A14U332 pin 2 should be approximately 19% of
the voltage at A14J23 pin 2.
k. If the voltage at U332 pin 2 is correct with A14J3 pins 9 and 10
shorted, but was incorrect with W10 connected, the YTO FM coil
is probably open; replace the A11 YTO.
l. Replace jumper A14J23. Remove the jumper and resistor from
A14J3. Reconnect W10 to A14J3.
Switch Control
Line (Pin #)
1
16
9
8
,
SAVE SAVE STATE
switch on.
LINE
,
RECALL STATE
Control Line
State (TTL)
High
High
Low
Low
, .
STATE 0
, .
STATE 0
Chapter 10