Table of Contents
Advertisement
E.
Safety Instructions for Battery Pack Charger
SHOCK HAZARD
To Avoid Injury:
•
Do not allow any liquid to get inside of the charger. Electric shock may result.
1.10 Tool Kinetic Specifications
1. Operating Conditions: Temperature 32 to 122. F (0 to +50 C)
2. Humidity: 0 to 95% non-condensing
3. Noise Level: A weighted emission sound pressure level at the work station LpA (ref 20μPa) is < 70dB(A). Value determined
according to ISO 15744-2002 * using as basic standards ISO 3744 and ISO 11203.
4. Vibration Level:
•
STANLEY Assembly Technologies hereby declares the following sound and vibration emission levels as required by the
Machinery Directive 98/37/EC.
•
A-weighted emission sound pressure level at the work station LpA (ref 20μPa) is < 70dB(A). Value determined accord-
ing to ISO 15744-2002 * using as basic standards ISO 3744 and ISO 11203.
•
Weighted emission root mean square acceleration level at the handle is < 2.5 m/s². Value determined according to ISO
28927-2:2009 * (3-axis)
•
Operating conditions for all measurements: full rated speed, no load, rated supply voltage.
VIBRATION HAZARDS
To Avoid Injury:
•
This information is provided to assist in making rough estimates of sound and vibration exposure levels in the workplace.
The declared emission values were obtained by laboratory type testing in accordance with the stated standards. Levels
measured in individual workplaces may be higher.
•
The actual exposure levels and risk of harm experienced by an individual user depends upon the work piece, workstation
design, duration of exposure, and the physical condition and work habits of the user. To help prevent physical impairment,
a program of health surveillance is highly recommended to detect early symptoms which may relate to sound and/or
vibration exposure, such that appropriate preventive measures may be taken.
Instruction Manual
WARNING
WARNING
Introduction
15
Advertisement
Table of Contents
