Specification; Intent Of Use; Tool Specification; Tool Dimensions - Stanley 70500 Instruction And Service Manual

O R I G I N A L I N S T R U C T I O N

2. SPECIFICATION

2.1 INTENT OF USE

The 70500 Module is principally a piston and cylinder assembly. When coupled hydraulically to a compatible hydraulic
power source and the relevant nose equipment is attached, it is then used to install speed rivets up to 4.8mm (3/16") in
diameter, in Industrial Environments.
The placing module may only be used in accordance with the operating instructions for placing Stanley Engineered
Fastening structural rivets.
DO NOT use under wet conditions or in the presence of flammable liquids or gases.
The safety instructions must be followed at all times.

2.2 TOOL SPECIFICATION

SPECIFICATION
Force: Pull at stated pull pressure
Pressure:
Hydraulic pressure
Stroke:
Piston Stroke
Cycle Time: Maximum
Weight:
Without nose equipment

2.3 TOOL DIMENSIONS

All dimensions are shown in millimetres.
METRIC
3.0 kN
140 bar
30.0 mm
1 second
kg
E N G L I S H
IMPERIAL
674 lbf
2030 PSI
1.18 in
-
lb
7