Stanley BR Series Instruction Manual page 49

STANLEY Assembly Technologies recommends:
• Schedule all power tools for periodic inspection and maintenance.
• Replace noticeably worn parts before wear occurs on adjoining parts.
• Use only genuine STANLEY replacement parts
A. Calibration
The BR-Series cordless tool's transducer must be calibrated annually or after repair to maintain its accuracy.
B. Repairs
Consult the repair parts lists for part identification and assembly instructions. Order all replacement parts by part number
from STANLEY Assembly Technologies or a STANLEY Assembly Technologies Authorized Distributor.
C. Lubrication
Proper lubrication is required for satisfactory operation.
This grease specification is for all nose assembly components, ballscrew, thrust bearing, planetary and bevel gearing, and
o-ring lubrication. STANLEY Assembly Technologies specifies the grease at the amounts indicated.
1. Ballscrew, Thrust Bearing, and Gearing
Every 250,000 rivets, disassemble ballscrew and gearing. Inspect for wear and replace any and all worn parts. Wipe compo-
nents clean and replace grease covering all components.
Place a light coating of Dow Corning MOLYKOTE® G-4700 Extreme Pressure Synthetic grease or Kluber Lubrication Isoflex
Topas NB 52 grease on all surfaces.
Fill housing to approximately 80% of capacity. Use Dow Corning MOLYKOTE® G-4700 Extreme Pressure Synthetic grease or
Kluber Lubrication Isoflex Topas NB 52 grease.
2. O-Rings
Coat O-rings with Parker O-lube before assembly.
3. Jaws
Every 5,000 - 10,000 rivets, dependent upon application, wipe jaws clean. Place a light coating of Dow Corning MOLYKO-
TE® G-4700 Extreme Pressure Synthetic grease or Kluber Lubrication Isoflex Topas NB 52 grease on jaw and jaw guide in-
terface surfaces. Alternatively, POP Jaw Lube (PRG510-130) may be used by dipping the end of the tool and allowing excess
lubricant to drip off before returning to service.
Instruction Manual
Maintenance
49