Table of Contents
Advertisement
2.11 Accessories
Since accessories, other than those offered by STANLEY, have not been tested with this product, use of such accessories with
this tool could be hazardous. To reduce the risk of injury, only STANLEY recommended accessories should be used with this
product.
Recommended accessories for use with your tool are available from your local service center.
2.12 Installing and Removing the Battery Pack
NOTE: For best results, make sure your battery pack is fully charged.
1. To install the battery pack into the tool handle, align the battery pack with the rails inside the tool's handle and slide it into
the handle until the battery pack is firmly seated in the tool and ensure that it does not disengage.
2. Installing the battery pack into the tool does not turn the tool on.
3. After the battery pack is inserted in the tool, press the start trigger switch to turn the tool on.
4. After the tool turns on it will connect wirelessly to the associated STANLEY controller if it is setup to do so. The orange PM
light will slowly blink until communication between the controller and the tool is made.
5. One of the two blue READY lights will illuminate when the tool is ready to run.
6. To remove the battery pack from the tool, press the release button and firmly pull the battery pack out of the tool handle.
7. Insert it into the charger as described in the charger section of this manual.
2.13 Connecting a Computer to a STANLEY Controller
Connect a computer to the Alpha Toolbox port using a standard CAT 5, 5E or 6 Ethernet cable. It does not matter if the cable is
straight-through or crossover. The computer's Ethernet port must be set to DHCP rather than a static IP Address to the computer.
Observe the computer's notifications to determine when the STANLEY controller has provided the IP Address.
1. Open a web browser, any current browser will do, and
2. Type http://atb.qpm into the uniform resource locator's (URL) bar.
3. The controller's web server will provide the Alpha Toolbox screens and controls.
Instruction Manual
Getting Started
31
Advertisement
Table of Contents
