Table of Contents
Advertisement
2.14
Set SSID
1. Click on the COMMUNICATIONS tab under the SETUP section.
2. Click on the wireless tab on the COMMUNICATIONS screen.
3. Enable wireless communications for the STANLEY controller, type in an SSID value, type in a PASSWORD and choose the
applicable REGION.
4. Click on Apply to save the changes.
2.15
Wireless Setup Parameters
•
High, Medium, Low - Enables the radio in the STANLEY controller.
•
Off - Disables the radio in the STANLEY controller.
1. Name
This parameter sets the Service Set Identifier (SSID) for the access point in the STANLEY controller. The maximum number of
case sensitive, alphanumeric (ASCII) characters is 32. It is recommended to use a value that best differentiates the station
under test from other stations. Use the up and down arrows on the keypad to insert characters. Use the right arrow to
move the cursor for the next character.
If left blank the default SSID for the STANLEY controller is QB-serial number, where
Serial number is the serial number of the controller; i.e. QB-032014007.
2. Password
This parameter sets the encryption key needed to connect a wireless device to the access point in the STANLEY controller.
Must be a minimum of 8 characters and no longer than 63 printable characters or 64 hexadecimal digits. Use the up and
down arrows on the keypad to insert characters. Use the right arrow to move the cursor to the next character.
3. Region
Select from the drop-down list the region of the world where the tool is operating. This selects the correct frequency chan-
nels allowed by that region.
2.16
Pairing Tool to Controller
STANLEY Assembly Technologies BR-Series cordless tools must be connected, or paired, to a controller to allow fastening
cycle data streaming to a network. The connection between the BR-Series cordless tool and the STANLEY Controller is an
IEEE 802.11b/g/n wireless link. This BR-Series cordless tool is a device that connects to the STANLEY Controller's access
point.
32
Cordless Tool
Advertisement
Table of Contents
