Mitsubishi Electric FR-E5NP Instruction Manual page 25

INVERTER SETTING
Pr. 338 "operation control
Control
command source"
location
selection
Pr. 339 "speed command source"
Low-speed operation command/
0
Remote setting clear (RL)
Middle-speed operation command/
1
Remote setting deceleration (RM)
High-speed operation command/
2
Remote setting acceleration (RH)
3 Second function selection (RT)
4 Current input selection (AU)
5 Start self-holding selection (STOP)
6 Output shut-off (MRS)
7 External thermal relay input (OH)
8 15-speed selection (REX)
PU operation-external (network)
16
operation switching (X16)
18 Magnetic flux-V/F switching (X18)
External : Control by signal from external terminal is only valid.
NET : Control from network is only valid.
Combined : Control from both external terminal and network is valid.
— : Control from both external terminal and network is invalid.
*1 When "7" (PU operation interlock function) is set in Pr. 79 "operation mode selection", only the external terminal is
made valid independently of the Pr. 338 and Pr. 339 settings, since this function is also used by terminal MRS.
0: NET 0: NET 1: External 1: External
0: NET 1: External
NET External
NET External
NET External
NET NET
— Combined
— —
Combined Combined
External External
NET External
External External
NET NET
18
0: NET 1: External
NET External
Pr. 59≠"0":
NET External Remote
setting
NET External
External External
— Combined
External External
External External *1
External External
NET External Pr. 59 = 0
External External
External External
Remarks