Table of Contents
Advertisement
Memory Transmission and Direct
Transmission
There are two methods for sending documents with this machine: memory
transmission and direct transmission.
Memory Transmission
With this method, the fax transmission starts after the entire document is
scanned and stored in the memory. The total number of pages is automati-
cally printed with the page number in the header. However, the memory may
become full if there are many pages in the document or if the data is large
due to the fine image quality (resolution).
Direct Transmission
With this method, the transmission is performed in real time in the transmis-
sion sequence of the destinations. If there are many pages in the document,
the fax can be sent with this method without the memory becoming full.
As a default, MEMORY TX (memory transmission) is selected. The
default setting can be changed from the UTILITY menu. For details,
refer to "FAX TX OPERATION" on page 2-24.
Direct transmission cannot be used together with duplex (dou-
ble-sided) document transmission.
Changing the Transmission Method
The transmission method can be temporarily changed from the default set-
ting.
1
Position the document to be faxed.
2
If desired, adjust the image quality.
The document image quality can be adjusted. For details, refer to
"Adjusting the Image Quality" on page 3-6.
3
Press the + or , key to select the current transmission method, and then
press the Select key.
The TX MODE screen appears.
If memory transmission has been specified as the default, MEMORY TX
appears. If direct transmission has been specified as the default,
DIRECT TX appears.
3-16
Memory Transmission and Direct Transmission
Advertisement
Table of Contents
