Troubleshooting - Kodak EasyShare 5100 User Manual

Chapter 8
Message
Bluetooth connection lost.
Check connection and resend.

Troubleshooting

AiO Fails to Power On
The power supply is not properly connected.
Make sure the power cord is connected to the power supply and plugged into a grounded power outlet
1
or power strip.
If you are using a power strip, make sure it is turned on.
2
If you are using a switched power outlet, make sure the switch is on.
3
Make sure the power outlet is supplying power.
4
If none of the above corrects the problem, contact Kodak support.
5
Bluetooth Device not Recognized
Probable Cause 1
The internal Bluetooth radio in the device may be turned off.
Corrective Action
Make sure the device is on and within range of the Bluetooth radio signal (30 ft., or 10 meters).
NOTE: The Bluetooth technology enabled device must use an BIP, OPP, or FTP profile.
Probable Cause 2
Sending device requires a PIN.
Corrective Action
Enter a PIN of 1111 into the sending device.
98
Bluetooth Message
Cause
Bluetooth
communication/connection
dropped while downloading a file
to the printer.
Action/Solution
Check the connection and
resend.
Kodak EasyShare 5100 AiO