Installing The Director 2/140 In The Rack; Securing The Front Mounting Brackets To The Rack; Securing The Rear Mounting Brackets To The Rack - HP StorageWorks 2/140 - Director Switch Installation Instructions Manual

Installation Instructions

Installing the Director 2/140 in the Rack

Use these steps to maneuver the Director 2/140 into the rack:
1. Using a lift device, position the Director 2/140 at the front of the cabinet.
2. If necessary, adjust the lift height so that the bottom of the Director 2/140 is
parallel with the shelf mounts in the rack.
3. Slide the Director along the shelf mounts and into the cabinet until the front
mounting brackets on the Director 2/140 contact the front cabinet rails.

Securing the Front Mounting Brackets to the Rack

Follow this procedure to secure the front mounting brackets attached to the Director
2/140 to the rack:
1. Secure one of the front mounting brackets to a cabinet rail by attaching three
Phillips panhead screws to the cage nuts you installed earlier.
2. Repeat step 1
rail.

Securing the Rear Mounting Brackets to the Rack

Follow this procedure to attach the Director 2/140 rear mounting plates to the rack
using the rear mounting bracket:
1. Align a rear mounting bracket with the cage nuts you installed earlier, and the
screw holes in the rear mounting plate attached to the Director 2/140.
2. Attach a rear mounting bracket to a rear mounting plate by installing three Phillips
panhead screws in the mounting plate holes. Do not tighten.
3. Adjust the position of the rear bracket so that the holes align with the cage nuts
installed in the cabinet rail.
4. Attach the rear mounting bracket to the cage nuts installed in the cabinet rail using
three Phillips panhead screws. Tighten securely.
5. Tighten the screws attached to the rear mounting plate.
6. Repeat step 1
rear rail.
10
to secure the other front mounting bracket to the remaining cabinet
through step 5 to attach a rear mounting bracket to the remaining
director 2/140 rack mount kit installation instructions