YASKAWA Solectria PVI 25TL-208 Installation And Operation Manual page 67

Installation and Operation Guide SOLECTRIA® PVI 25TL-208, PVI 50TL-480 and PVI 60TL-480
While the inverter is in Normal Operation mode (and not in screen saver) the interface indicates PV
voltage, PV current, grid voltage, instant power, daily generated power and time. This is the "Default
Indication Interface."
(3) Indication of standby mode:
The inverter will enter Standby mode when the output voltage and power of PV modules do not meet the
startup conditions or PV voltage and input power are lower than the set value. The inverter will check
automatically whether it meets the startup conditions in this mode until it turns back to normal mode.
The inverter will switch from standby mode to fault mode if a malfunction occurs.
DOCR-071030-A (10/7/2022)
E-total: KWh
kWh
60
45
30
15
3 6 9
Running Status Cycle Display
Status Addr:000
Figure 4-3 Default Display Interface for Normal Operation
History
Num Time&Date
001 2015/10/22 12:20:08
002 2015/10/22 12:30:11
003 2015/10/22 13:20:08
004 2015/10/24 10:20:04
005 2015/10/24 09:31:08
006 2015/10/25 12:20:08
2015/10/25 16:11:18
007
008 2015/10/25 17:21:07
Figure 4-4 Fault Indication Interface
E-total: KWh
Running Status Cycle Display
kWh
200
160
120
80
40
6 8 10
Standby 485Addr
Figure 4-5 Standby mode
E-Today: kWh
12 15 18 21 24 h
2015-10-22 10：00:00
Error Code
W0130
P0020
F0140
F0150
W0130
F0070
P0360
P0050
P1/1
E-Today: kWh
12 14 16 18 20 h
2015-10-22 05：00:00
Page 67 of 131