Lincoln Electric VRTEX 360 Service Manual page 97

F-40
MONITOR AND PEDESTAL REMOVAL AND REPLACEMENT PROCEDURE
Power Cord
REMOVAL PROCEDURE
1. Remove input power.
2. Disconnect the power supply cord and VGA
(blue) input cable from monitor.
F.13.
3. Using a phillips screwdriver, remove two bottom
monitor mounting screws. See Figure F.13.
4. Loosen the top two phillips screws and carefully
separate monitor from pedestal.
Note: It is not necessary to completely remove the
top two phillips screws unless a new monitor
is required.
All manuals and user guides at all-guides.com
TROUBLESHOOTING AND REPAIR
(continued)
FIGURE F.13 – VGA & POWER CORD LOCATION
Phillips Screws (4)
See Figure
VRTEX
VGA
5. The monitor can now be removed.
Note: It is not necessary to remove the pedestal if
just the monitor is to be replaced
6. Using a 7/16" wrench, remove the monitor
pedestal mounting screws. Note washer place-
ment upon removal. See Figure F.14.
7. Remove pedestal.
TM 360
F-40