Lincoln Electric VRTEX 360 Service Manual page 147

F-90
REMOVAL AND REPLACEMENT PROCEDURE (continued)
REMOVAL PROCEDURE
1. Remove input power.
2. Perform the Monitor and Pedestal Removal
3. Perform the Case Cover Removal Procedure. Procedure.
4. Locate the VR SMAW Device. See Figure F.41.
5. Disconnect plug J3 from the relay board. See
Figure F.22.
6. Using the 3/8" wrench, remove the two screws
holding the sheet metal strain relief to the front
panel. See Figure F.42.
7. Locate and disconnect the 16 pin molex style
cable splice. See wiring diagram.
All manuals and user guides at all-guides.com
TROUBLESHOOTING AND REPAIR
VR SMAW (STICK) DEVICE
FIGURE F.41 – VR SMAW DEVICE LOCATION
VRTEX TM 360
F-90