Lincoln Electric VRTEX 360 Service Manual page 23

B-5
Users should first adjust the helmet so it fits comfort-
Helmet
ably. Adjustments can be made by depressing and
turning the knob at the back of the helmet in until the
desired size is achieved. If necessary, the user may
also have to adjust the top crown adjustment to fit their
head size.
HELMET FUNCTIONS
HEAD GEAR
FORE / AFT ADJUSTMENT
CROWN
ADJUSTMENT
RATCHET KNOB
The helmet has an FMD (Face Mounted Display) on
the inside. These FMD lenses display the virtual weld
and environment to the user. The lenses can be shift-
ed left and right to fit comfortably by applying gentle
pressure. In addition, the lenses can be shifted for-
ward and back. The user should make sure the lenses
are parallel to their eyes. Keep the lenses clean at all
times. See Cleaning and Maintenance Section.
HELMET LENSES
LENSES
When not in use, the helmet should be hung from the
stand or placed in the right front drawer to avoid being
damaged.
All manuals and user guides at all-guides.com
OPERATION
TILT ADJUSTMENT
PIN HOLES FOR
ADJUSTMENT
EAR
BUDS
VRTEX TM
The coupon drawer houses the physical coupons.
Coupon Drawer
When not in use, the coupons should be stored there.
To open the drawer, press the top indent down, and
slide the drawer out. Each coupon fits in its own area
defined by the foam locator in the drawer.
COUPON DRAWER
The coupons represent the various workpieces that the
Coupons
user will virtually weld.
process, they provide physical feedback to the student.
The coupons have been factory calibrated at Lincoln
Electric.
There are five VR Coupons:
1. Flat Plate
2. Tee Joint
3. 3/8" Groove Joint w/Backing Bar
4. 2" Diameter XXS Pipe
5. 6" Diameter Schedule 40 Pipe
COUPONS
5
4
1
360
B-5
During the virtual welding
2
3