Lincoln Electric VRTEX 360 Service Manual page 117

F-60
5VDC SUPPLY MODULE REMOVAL AND REPLACEMENT PROCEDURE
REMOVAL PROCEDURE
1. Remove input power.
2. Perform the Monitor and Pedestal Removal
Procedure.
3. Perform the Case Cover Removal Procedure.
4. Locate the 5VDC Supply Module. See Figure
F.23.
Note: There are two supply modules located next
to each other. Make certain that you are
removing the correct module.
5. Using a small flathead screwdriver, remove
leads 102A (white), 103B (pink/red) and the
green ground lead from the bottom of the
Supply Module. See Figure F.24.
All manuals and user guides at all-guides.com
TROUBLESHOOTING AND REPAIR
(continued)
FIGURE F.23 – 5 VOLT SUPPLY LOCATION
VRTEX
5 VOLT SUPPLY
6. Label and remove the positive and negative
leads (81,81,50,50) from the top of the 5VDC
Module using the small flathead screwdriver.
See Figure F.24.
7. Push down on the release tab and lift up to
remove the 5VDC Supply Module from the DIN
rail.
TM 360
F-60