Lincoln Electric VRTEX 360 Service Manual page 121

F-64
12/15VDC SUPPLY MODULE REMOVAL AND REPLACEMENT PROCEDURE
REMOVAL PROCEDURE
1. Remove input power.
2. Perform the Monitor and Pedestal Removal
Procedure.
3. Perform the Case Cover Removal Procedure.
4. Locate the 12/15VDC Supply Module.
Figure F.25.
Note: There are two supply modules located next
to each other. Make certain that you are
removing the correct module.
5. Using a small flathead screwdriver, remove
leads 102B (white), 103C (pink/red) and the
green ground lead from the bottom of the
12/15VDC Supply Module. See Figure F.26.
All manuals and user guides at all-guides.com
TROUBLESHOOTING AND REPAIR
(continued)
FIGURE F.25 – 12/15 VOLT SUPPLY MODULE LOCATION
See
VRTEX
12/15 VOLT SUPPLY
6. Label and remove the positive and negative
leads (71, 71, 72, 72) from the top of the Supply
Module using the small flathead screwdriver.
See Figure F.26.
7. Push down on the release tab and lift up to
remove the 12/15VDC Supply Module from the
DIN rail.
TM 360
F-64