Table of Contents
Advertisement
Preparations before recording – Power supply
Charging the battery
(2)
(3)
1
Connect the DC plug of the AC adaptor to the DC IN 12 V connector of battery
charger.
2
Connect the AC mains lead to the AC adaptor.
•
Perform step (2) first, and then step (3). Insert the AC mains lead all the way in until it stops.
3
Insert the battery into the battery charger.
•
Slide the battery horizontally into the battery charger along the "
•
The corresponding CHARGE indicator lights and charging starts.
•
The CHARGE indicator turns off when charging is complete. Slide the battery to remove it.
•
Do not use any other AC adaptors except the supplied one.
•
We recommend using Panasonic batteries (
•
If you use other batteries, we cannot guarantee the quality of this product.
•
Do not heat or expose to flame.
•
Do not leave the battery(ies) in a car exposed to direct sunlight for a long period of time with doors and windows closed.
•
Do not expose to low air pressure at high altitudes.
•
Do not expose to extremely low air pressure, as this may result in explosions or leakage of flammable liquids and gases.
•
The battery charger will determine the status of the battery after the battery is mounted. Therefore, it may take some time
until the charging lamp is to illuminate. Mount the battery again if the charging lamp does not illuminate after ten seconds or
longer has elapsed.
•
When two quick charging compatible batteries are mounted, the quick charging on the <CHARGE1> side will take priority,
and the charging on the <CHARGE2> side will be normal charging. Once the charging of the <CHARGE1> side proceeds,
the charging on the <CHARGE2> side will switch to quick charging.
Also, depending on the charging status of the battery, the indicator on the battery that is mounted on the <CHARGE2> side
may turn off.
•
The battery charger will perform optimal charging after determining the status of the battery. Once the charging is started,
the indicator for quick charging compatible battery will flash. Also, if it is charging on both <CHARGE1> side and
<CHARGE2> side, charging of both batteries will stop when either one of the battery is mounted/removed, or replaced. It
will start the charging again after determining the status of the batteries.
•
Mount the battery to be charged prioritized on the <CHARGE1> side when charging.
(4)
(1)
" mark.
Power supply:
31).
32
Advertisement
Table of Contents
