Panasonic HC-X2 Operating Instructions Manual page 293

Notes – Warning system
[CARD ERROR <SLOT 1>]/
[CARD ERROR <SLOT 2>]
[END]
(Memory card status display)
(Once every second, flash in red)
Remaining recording capacity display
of the memory card
(Flashes once every second during
recording)
A data error caused by the memory
card has occurred during recording or
playback.
The remaining recording capacity of
the memory card has exhausted
during recording.
Battery is almost consumed.
The remaining recording capacity of
the memory card is getting low.
293
(When it was recording)
•
All of the tally lamps and the card access lamps (orange)
flash 4 times each second, and an alarm sounds.
•
Recording is stopped.
•
The memory card where the error has occurred is write
protected after recording stops. Replace the memory card
in the card slot where the error has occurred.
(When it was playing back)
•
Playback is stopped.
All of the tally lamps and the card access lamps (orange)
flash 4 times each second, and an alarm sounds.
•
Recording is stopped.
•
Replace the memory card or delete unnecessary clips.
All of the tally lamps flash once every second.
•
The current operation will continue.
•
Replace with a fully charged battery, or connect the AC
adaptor.
•
Recording will continue.
•
Replace the memory card as necessary.