Using The Tftp Put Command To Reload Or Update Firmware - Intermec EasyLan AW02 User Manual

Using the TFTP PUT Command to Reload or Update Firmware

EasyLAN Wireless User's Manual
Parameter Required Value
Baud rate 115200
Data bits 8
Stop bits 1
Parity None
Flow control None
4 Press Enter to get the
Instead of the
Local>
the prompt. For help, see Step 3 on page 89.
Boot>
5 Type
set load xmodem
begin your Xmodem file transfer now," appears.
6 From the Transfer menu, select Send File. The Send File dialog box
appears.
7 Click Browser to browse to and select the firmware you downloaded in
Step 1.
8 In the Protocol field, select Xmodem.
9 Click Send. A dialog box displays the status of the file transfer.
10 When EasyLAN Wireless is finished rebooting, press Enter to get the
prompt.
Local>
11 Type and press Enter to verify that you installed the correct
sh ver
version of firmware.
12 Type and press Enter. Your EasyLAN Wireless is now ready to
exit
communicate or configure.
You can use the
tftp put
download a firmware file from your PC.
Note: You should use TFTP to reload or upgrade firmware only if the
printer with EasyLAN Wireless and your PC are on the same network
segment.
Note: Currently, if your EasyLAN Wireless is configured to use 802.1x
security with LEAP, you need to temporarily change the wireless modes of
your EasyLAN Wireless and your PC to Ad-hoc mode before you can
perform these procedures. For help, see "Configuring Wireless Network
Parameters With the Web Browser Interface" on page 35.
Chapter 3 — Managing EasyLAN Wireless
prompt.
Local>
prompt, you might see the
and press Enter. The message, "You may
command and a command window to
prompt or
Local:
73