Table of Contents
Advertisement
EasyLAN Wireless User's Manual
TCP/IP Console Commands (continued)
Command
set ip pro status
set ip ran status
set ip rar nn
set ip re status
set ip ro n.n.n.n
set ip su n.n.n.n
set ip tcp status
set ip tel status
set ip tftp status
set ip ti nn
set ip wi nn
set servi servicename
ip status
set servi servicename
tcp nn
sh ip
sh ip ac
Appendix A — Console Commands
Description
Determines if you want EasyLAN Wireless to send a
probe packet on TCP connections with no data
traffic. If you enable this feature and EasyLAN
Wireless does not receive an acknowledgement, it
closes the connection. Where status is
or
for disabled. The default is disabled.
dis
Allows or disallows access to a range of remote
addresses. Where status is
en
disabled, or
for all addresses. The default is an
all
empty list of IP addresses.
Enables or disables the setting of a default router
and/or subnet mask based on the source of a RARP
IP address set. Where nn is
subnet,
for no router, or
2
default is
.
0
Determines if EasyLAN Wireless waits for an LPD
job that has been terminated before completion to
be resent. If the LPD job is resent, EasyLAN
Wireless continues printing the job where it had
stopped. Where status is
en
disabled. The default is disabled.
Sets the default router address. Where n is a number
from 0 to 255. The default is 0.0.0.0.
Sets the subnet mask. Where n.n.n.n n is a number
from 0 to 255. The default is 0.0.0.0.
Enables or disables the raw TCP (9100) protocol.
Where status is
for enabled or
en
The default is enabled.
Enables or disables the Telnet protocol. Where status
is
for enabled or
for disabled. The default is
en
dis
enabled.
Enables or disables the TFTP protocol. Where status
is
for enabled or
for disabled. The default is
en
dis
enabled.
Sets the TCP inactivity timeout. Where nn is the
number of minutes. The default is 1 minute.
Sets the maximum TCP/LPD window size. The
default is 10240.
Enables or disables TCP/IP jobs on specified service.
Where servicename is the name of the service and
status is
for enabled or
en
dis
Sets the TCP port number (>1023) on the specified
service. Where servicename is the service you are
modifying and nn is the TCP port number.
Shows LPD/TCP/Telnet parameters.
Shows IP addresses that are allowed to access
EasyLAN Wireless.
for enabled
en
for enabled,
for
dis
for both,
for no
0
1
for neither. The
3
for enabled or
for
dis
for disabled.
dis
for disabled.
95
Advertisement
Table of Contents
Troubleshooting
