Table of Contents
Advertisement
This Manual Assumes the Update Password Has Been Configured
Configuring the TCP/IP Parameters
Configuring the TCP/IP Parameters With the Web Browser Interface
EasyLAN Wireless User's Manual
4 Enter the new update password in both the Enter new Network Card
Update Password field and the Confirm new Network Card Update
Password field.
5 If the page contains the Network Card Update Password field, enter
the current update password. The default is
6 Click Submit. The message, "Data updated successfully," appears. The
new update password is effective immediately; you do not have to reset
EasyLAN Wireless.
7 You can click any of the commands along the left side of the page. To
exit, click Logout and close your web browser.
This manual assumes that you have set the update password to
in lowercase. Therefore, the web browser interface screens shown in this
manual include the Network Card Update Password field, where you
must enter the current update password before you can click Submit.
If you have not configured the update password, you will not see the
Network Card Update Password field on your screens.
This section explains how to use the web browser interface to configure
advanced TCP/IP parameters. It also explains how to use ARP to set a
static IP address.
Note: If you are using a DHCP server on your network, it may have
already assigned EasyLAN Wireless its TCP/IP parameters, and no further
configuration is necessary. However, when you configure your printer
port and use the web browser interface, EasyLAN Wireless needs a static
IP address. Assign EasyLAN Wireless an IP address outside the range
reserved for DHCP (see your DHCP server manual for details).
1 Log in to the EasyLAN Wireless web page. For help, see "Logging In to
the EasyLAN Wireless Web Browser Interface" on page 25.
2 Click TCP/IP. The Configure TCP/IP page appears.
Chapter 2 — Configuring EasyLAN Wireless
.
intermec
intermec
29
Advertisement
Table of Contents
Troubleshooting
