Intermec EasyLan AW02 User Manual page 40

Chapter 2 — Configuring EasyLAN Wireless
28
There are two ways to configure the update password:
• You can use the Configure Network Card Update Password
command in the web browser interface, as described in the following
procedure.
• You can use the console command
described on page 91.
If you enable the update password, be aware of these two results:
• You will need to enter this password before making any changes to the
configuration and before updating the firmware. Whenever the
Network Card Update Password field appears, you must enter the
update password.
• When you use console commands, you will see the
instead of the
Local>
prompt, but you can display information about the EasyLAN
Local:
Wireless configuration. To make changes, you need to enter the
command and enter the update password. The
appears, and you can use the
details about the
unpro
To configure the update password using the web browser interface
1 Log in to the EasyLAN Wireless web page. For help, see "Logging In to
the EasyLAN Wireless Web Browser Interface" on page 25.
2 Click Admin. The Web Admin Configuration page appears.
3 Click Configure Network Card Update Password. The Configure
Network Card Update Password page appears.
set protect password
prompt. You cannot make any changes from the
commands to make changes. For
set
command, see page 93.
EasyLAN Wireless User's Manual
, as
prompt
Local:
unpro
prompts
Local>