Transfer Settings - ZyXEL Communications NAS326-2T User Manual

Figure 128 Control Panel > Service > FTP > General Settings
The following table describes the labels in this screen.
Table 95 Control Panel > Service > FTP > General Settings
LABEL
Enable FTP
Connection Limit
Idle Timeout
Port Number
Enable Anonymous
FTP Access
Apply
Reset

10.6.2 Transfer Settings

Click Control Panel > Service > FTP > Transfer Settings to open the following screen.
Chapter 10 Control Panel: Service
DESCRIPTION
You can use FTP to send files to the NAS or get files from the NAS. Select this check box to
allow users to connect to the NAS via FTP; otherwise clear the check box.
Enter the maximum number of concurrent FTP connections allowed on the NAS in this field.
See your screen for your model's connection limit.
Enter the length of time that an FTP connection can be idle before timing out. The timeout
limit is 300 minutes.
This is the port number used by the NAS for FTP traffic.
Select this check box to allow any user to log into the NAS using 'anonymous' as a
username and no password. Any other name is considered a username, so must be valid
and have a corresponding correct password.
Note: If users log into the NAS using 'anonymous' as a username, they can only
access files in the shares to which the "pc-guest" user is given access. See
Section 7.3 on page
Click this to save your changes.
Click this to restore your previously saved settings.
NAS Series User's Guide
163
104.