Hussmann Impact Excel M5X Installation And Service Manual page 8

I
1-4
NSTALLATION
Level the case by all four corners. Start at the
rear by placing as needed the provided shims
under each end of the rear base rail. The shims
are long enough to allow the adjoining case to be
leveled with the same shim. When the rear of the
case is level end-to-end, move to the front of the
case. Use an 18 mm open end wrench to screw
down the levelers at each front corner so that the
front is also level from end-to-end. At this point,
check to see if the case is level front-to-rear. If it
is not, turn each front corner leveler up or down
the same amount of turns until the case is level
front-to-rear.
Level on
Hand Rail
Adjustable
Leg Leveler
Raise
The case should be solidly supported at least
every 4 feet (1220 mm). Once the case is level, if
any gaps are present, shims should be inserted
under the rear base rail approximately in line
with the center front support legs to support the
rear of the case. At the front of the case, screw
down the levelers on each of the center support
legs so that they contact the floor and support the
front of the case.
P/N 0463880_E
Lower
Levels
Leveling Single Deck
Merchandisers
Levels
Leveling
Multi-deck
Merchandisers
NOTE: Do not place levels
on Display Pans or
on Shelves.
Shim
Adjust
Legs
Shim
Adjust
Legs
. .
WWW HUSSMANN COM