Hussmann Impact Excel M5X Installation And Service Manual page 16

I
1-12
NSTALLATION
Starter
Bumper
b. Install full length bumpers and internal
trims offset across joints. Make sure that no
gaps exist between sections. Continue
installing the bumpers the length of the line
up.
5. Once all except the last section of bumper
have been installed refrigerate the case line up for
at least six (6) hours. The last section of bumper
should be kept inside a cooler or refrigerated
case during this time. This will allow the
bumper to contract.
6. Go to the right end of the line up and tap the
bumper to close any gaps.
P/N 0463880_E
Retainer
Internal Joint Trims
Merchandiser
Joint
Full Length
Bumper
7. Measure and cut last
sections of bumper. Use a
miter box and fine-tooth
saw to cut last bumper to
length. Install the last sec-
tion.
8. Remove protective film from bumper once
installation is complete.
Bumper
Miter Box
. .
WWW HUSSMANN COM