Align End Frames - Hussmann Impact Excel M5X Installation And Service Manual

P/N 0463880_E
Gasket Detail Views
Side View
Case Perimeter
Foam-to-Metal Gap
Top View
Side
A continuous bead of silicone sealant/
caulk may be used in addition to gaskets
on mating surfaces but must not be used
in lieu of gaskets.
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.

Align End Frames

IMPORTANT:
TIGHTENING ORDER
NOTE: Cases must be level before joining.
Top
1. Insert alignment pin at lower front and lower
back.
2. Remove factory-installed nut retainer from
lower front end frame(s).
3. Move the second case as close to the first as
possible by pushing or using lever bar (mule).
Lap
Gaskets
4. Insert the alignment rod (
6 in.) through hole in top rail, align and insert
into second to rail. Refer to Glass Front detail
for location.
5. Match alignment pins with corresponding
holes in foam bottom and canopy.
ALIGNMENT ORDER IS DIFFERENT FROM
! R
EFER TO THE ILLUSTRATION
R A
EFER TO LIGNMENT DIAGRAM AND
DETAIL VIEWS ON NEXT TWO PAGES
Medium Temperature
1-7
.
1
/ in. diameter x
4
.
Excel