Autopark - Jeep WRANGLER 4Xe 2022 Manual

ENGINE START/STOP Button Functions — With
Driver's Foot Off The Brake Pedal (In PARK Or
NEUTRAL Position)
The ENGINE START/STOP button operates similar
to an ignition switch by providing three positions:
OFF, ACC and ON/RUN. To change the ignition
position without starting the vehicle (to power
certain accessories), follow these steps:
1. Start with the ignition in the OFF position.
2. Push the ENGINE START/STOP button once,
without the brake pedal being pressed, to
place the ignition in the ACC position
(instrument cluster will display "ACC").
3. Push the ENGINE START/STOP button a
second time, without the brake pedal being
pressed, to place the ignition in the ON/RUN
position (instrument cluster will display
"Ignition or Accessory On").
NOTE:
The vehicle is not able to be driven in the

Ignition or Accessory On position, see
"Achieving vehicle READY using the ENGINE
START/STOP button" previously defined in
this section for further information.
4. Push the ENGINE START/STOP button a third
time, without the brake pedal being pressed,
to return the ignition to the OFF position
(instrument cluster will display "OFF").
NOTE:
Only press one pedal at a time while driving the
vehicle. Torque performance of the vehicle could
be reduced if both pedals are pressed at the same
time. If pressure is detected on both pedals simul-
taneously, a warning message will display in the
instrument cluster Ú page 36.
A P
UTO ARK
AutoPark is a supplemental feature to assist in
placing the vehicle in PARK should the situations
on the following pages occur. It is a back-up system
and should not be relied upon as the primary
method by which the driver shifts the vehicle into
PARK.
The conditions under which AutoPark will engage
are outlined on the following pages.
WARNING!
Driver inattention could lead to failure to place

the vehicle in PARK. ALWAYS DO A VISUAL
CHECK that your vehicle is in PARK by verifying
that a solid (not blinking) "P" is indicated in
the instrument cluster display and on the gear
selector. If the "P" indicator is blinking, your
vehicle is not in PARK. As an added precau-
tion, always apply the parking brake when
exiting the vehicle.
STARTING AND OPERATING
AutoPark is a supplemental feature. It is not

designed to replace the need to shift your
vehicle into PARK. It is a back-up system and
should not be relied upon as the primary
method by which the driver shifts the vehicle
into PARK.
If the vehicle is not in PARK and the driver turns off
the engine, the vehicle may AutoPark.
AutoPark will engage when all of these conditions
are met:
Driver's door is ajar or the driver's door is

removed and the driver is not on the seat (seat
pad sensor detects driver missing)
Vehicle is not in PARK

Vehicle speed is 1.2 mph (1.9 km/h) or less

Ignition is switched from ON/RUN to OFF

NOTE:
For Keyless Enter 'n Go™ equipped vehicles, the
engine will turn off and the ignition switch will
change to ACC position. After 30 minutes the
ignition switches to OFF automatically, unless the
driver turns the ignition switch OFF.
(Continued)
45
WARNING!
4