Jeep WRANGLER 4Xe 2022 Manual page 11

Max Regeneration
Max Regeneration is a supplemental feature of the
RBS. When activated, it will use the RBS to help
slow the vehicle when the driver releases the
accelerator pedal. This feature allows you to
moderately reduce driving speed without pressing
the brake pedal. It is always necessary to apply the
brake pedal to bring the vehicle to a complete stop.
Max Regeneration Button
This feature can be activated by pressing the Max
Regeneration button, below the radio screen.
NOTE:
The Max Regeneration feature will remain on once
selected, even after the vehicle is restarted.
E-S M
ELECT ODE
This system allows the driver to select different
modes by pushing the following buttons located
below the headlight switch.
E-Select Mode Switch
Hybrid: Depletes electric range first, then gas

range.
Automatically switches between using gas

and battery for greatest efficiency and
performance.
Best HVAC and acceleration performance.

Default Mode.

GETTING TO KNOW YOUR VEHICLE
Electric: Prevents the engine from running,

unless you absolutely need it.
Acceleration and heating performance may

be degraded.
Engine will switch on during a Wide Open

Throttle (WOT) event, or if cruise control
requires it.
Vehicle will automatically switch to Hybrid

mode upon reaching 0% State Of Charge
(SOC) or due to system needs.
Not allowed with manual gate operation

unless in 4WD Low and Selec-Speed
Control (SSC) is active.
E-Save: Engine only. Saves the current SOC/

Electric range for later.
SOC/Electric range may increase, but will

not decrease under most driving conditions.
Under heavy load, such as while pulling a
trailer, SOC may decrease.
Engine may turn off at a stop.

You can further customize the E-Save oper-

ation in the Radio, refer to the Uconnect
Settings section of your owner's manual for
more information.
9
2