Table of Contents
Advertisement
10
GETTING TO KNOW YOUR VEHICLE
HIGH VOLTAGE CHARGING OPERATION
SAE J1772 C
I
HARGING
NLET
Your vehicle uses an industry standard
SAE J1772 charge inlet (vehicle charge inlet) for
both AC Level 1 (120 V) and AC Level 2 (240 V)
charging.
Vehicle Charge Inlet Location
Open the charge port door by pushing near the rear
outer edge of the door, near the center to unlatch.
Then use your hand to rotate charge port door to
the full open position. To close the charge port
door, rotate the door to the closed position then
engage the door latch by pushing on the rear outer
edge near the center.
AC L
1 C
EVEL
HARGING
(120 V
, 12 A
)
OLT
MP
Your vehicle is equipped with a 120 Volt AC,
SAE J1772 Level 1 Electric Vehicle Supply
Equipment (EVSE), also referred to as a Portable
Charging Cordset. AC Level 1 charging requires a
conventional NEMA 5-15R 120 Volt AC grounded
wall receptacle along with the EVSE provided with
the vehicle.
Portable Charging Cordset (EVSE)
WARNING!
INSTRUCTIONS PERTAINING TO A RISK OF
FIRE OR ELECTRIC SHOCK: Shock, fire, property
damage, or personal injury may occur if the
Portable Charging Cordset (EVSE) is not used
properly. There are no serviceable parts
contained in the Portable Charging Cordset
(EVSE). Any attempt to service it may result in
shock, fire, property damage, or personal injury.
The EVSE is stored in the rear cargo area below the
load floor. To access this area, lift up the cargo
strap of the load floor cover, and remove the EVSE
from the storage bag in the bin below.
Hide quick links:
Advertisement
Table of Contents
