Starting And Operating; Starting The Vehicle; Normal Starting - Jeep WRANGLER 4Xe 2022 Manual

44

STARTING THE VEHICLE

Before starting your vehicle, adjust your seat,
adjust both inside and outside mirrors, and fasten
your seat belts.
WARNING!
When exiting the vehicle, always remove the

key fob from the vehicle and lock your vehicle.
Never leave children alone in a vehicle, or with

access to an unlocked vehicle.
Allowing children to be in a vehicle unattended

is dangerous for a number of reasons. A child
or others could be seriously or fatally injured.
Children should be warned not to touch the
parking brake, brake pedal or the transmis-
sion gear selector.
Do not leave the key fob in or near the vehicle,

or in a location accessible to children, and do
not leave the ignition of a vehicle equipped
with Keyless Enter 'n Go™ in the ACC or ON/
RUN position. A child could operate power
windows, other controls, or move the vehicle.

STARTING AND OPERATING

Do not leave children or animals inside parked

vehicles in hot weather. Interior heat buildup
may cause serious injury or death.
Activate the Propulsion System Active (PSA) or
Ready to Drive mode with the gear selector in the
PARK (P) position. Apply the brake before shifting
to any driving range.
In extreme temperatures, high or low, the high
voltage battery may need to be conditioned, and
therefore may require the vehicle to be plugged in
Ú page 8.
NOTE:
If the ignition switch does not change with the push
of a button, the key fob may have a low or depleted
battery. In this situation, a back-up method can be
used to operate the ignition switch. Put the key fob
against the ENGINE START/STOP button and push
to operate the ignition switch.
(Continued)
WARNING!
N S
ORMAL TARTING
Achieving vehicle READY using the ENGINE START/
STOP button.
1. The transmission must be in PARK or
NEUTRAL.
2. Press and hold the brake pedal while pushing
the ENGINE START/STOP button once.
3. The READY indicator will appear in the
instrument cluster display when the vehicle is
in Ready to Drive mode, which may include the
start of the engine depending on conditions
such as battery state of charge and engine
temperature.
4. If you wish to terminate Ready to Drive mode,
push the button again.