Jeep WRANGLER 4Xe 2022 Manual page 17

5. To stop the charging process, disconnect the
vehicle charge connector first and then the
charging cable from the wall receptacle. To
disengage the vehicle coupler, remove the
connector from the vehicle charge inlet.
Removing The Charge Connector From The
Vehicle Charge Inlet
6. Close the inlet door when an EVSE is not
connected to the vehicle.
NOTE:
It is good practice to keep the ignition in the
OFF position while conducting Level 1 charging.
This minimizes any additional vehicle loads the
EVSE has to support. The additional electrical
loads will extend the high voltage battery charging
time.
Troubleshooting Using The Status
Indicator Display
If the vehicle is not charging properly, consult the
status indicator lights.
The Green LED signals correct operation of the
system.
The Red LED signals a failure in the charging
system.
The Yellow LED signals a failure with the outlet.
GETTING TO KNOW YOUR VEHICLE
LED Indicator Lights
1 — Green LED
2 — Red LED
3 — Yellow LED
Any faults in charging are displayed by the LEDs,
either steady or flashing, located on the status
indicator display of the EVSE. Refer to the following
table.
15
2