Jeep WRANGLER 4Xe 2022 Manual page 28

26 GETTING TO KNOW YOUR VEHICLE
IGNITION SWITCH
This feature allows the driver to operate the
ignition switch with the push of a button as long as
the key fob is in the passenger compartment.
NOTE:
This vehicle is equipped with an automatic
shutdown feature. If the vehicle is left with the
ignition in the RUN position (engine not running)
with gear selector in PARK for 30 minutes, it will
automatically turn off the vehicle. If the driver door
is opened, then closed while propulsion is active
and the vehicle is in PARK, the vehicle will shut
down. Notifications have been designed into this
feature to raise awareness of the timed event. The
instrument cluster display will show the message
"Ready to Drive" accompanied with three audible
chimes while exiting. The interior warnings will
occur regardless of whether the key fob remains in
the vehicle or is removed. The horn will sound
three times, and the turn signals will flash, if the
key fob is removed from the vehicle while the
ignition state is in READY mode.
To restart the vehicle, follow the normal process for
starting your vehicle.
The Keyless Push Button Ignition has several
operating modes that are labeled and will
illuminate when in position. These modes are
OFF, ACC, RUN, and START.
NOTE:
Pushing the START/STOP ignition button may

only activate the Electric Propulsion system and
not start the vehicle's engine (if running the
engine is not currently required by the Hybrid
system). READY will show in the instrument
cluster display whenever the vehicle is oper-
ating in Electric mode and the vehicle is
stationary.
If the vehicle's ignition is in either ACC or RUN,

the vehicle charge indicator may not display a
value greater than 99% state of charge due to
vehicle loads.
Keyless Push Button Ignition
1 — OFF
2 — ACC
3 — RUN
The ignition can be placed in the following
positions:
OFF
The vehicle is stopped

Some electrical devices are available

ACC
Some electrical devices are available

Mechanical power (Vehicle Propulsion) is

not available
RUN
Driving position

All electrical devices are available

As long as READY appears in the instrument

cluster display, it does not matter if the engine
is running or not, vehicle propulsion is available
START
The vehicle will start

NOTE:
Vehicle propulsion is only available after the
vehicle has passed through the START position.