Autopark - Jeep GRAND CHEROKEE 2023 Owner's Manual

A P
UTO ARK
AutoPark is a supplemental feature to assist with placing
the vehicle in PARK (P) should the situations on the
following pages occur. It is a back-up system and should
not be relied upon as the primary method by which the
driver shifts the vehicle into PARK.
The conditions under which AutoPark will engage are
outlined on the following pages.
WARNING!
 Driver inattention could lead to failure to place the
vehicle in PARK. ALWAYS DO A VISUAL CHECK that
your vehicle is in PARK by verifying that a solid (not
blinking) "P" is indicated in the instrument cluster
display and on the gear selector. If the "P" indicator is
blinking, your vehicle is not in PARK. As an added
precaution, always apply the parking brake when
exiting the vehicle.
 AutoPark is a supplemental feature. It is not
designed to replace the need to shift your vehicle
into PARK. It is a back up system and should not be
relied upon as the primary method by which the
driver shifts the vehicle into PARK.
If the vehicle is not in PARK and the driver turns off the
engine, the vehicle may AutoPark.
AutoPark will engage when all of these conditions are met:
 Vehicle is equipped with an 8-speed transmission
 Vehicle is not in PARK
 Vehicle speed is 1.2 mph (1.9 km/h) or less
NOTE:
For Keyless Enter 'n Go™ equipped vehicles, the engine
will turn off and the ignition switch will change to the ON/
RUN position. After 30 minutes the ignition switches to
OFF automatically, unless the driver turns the ignition
switch OFF.
If the vehicle is not in PARK and the driver exits the vehicle
with the engine running, the vehicle may AutoPark.
AutoPark will engage when all of these conditions are met:
 Vehicle is equipped with an 8-speed transmission
 Vehicle is not in PARK
 Vehicle speed is 1.2 mph (1.9 km/h) or less
 Driver's seat belt is unbuckled
 Driver's door is ajar
 Brake pedal is not pressed
STARTING AND OPERATING
The message "AutoPark Engaged Shift To P Then Shift To
Gear" will display in the instrument cluster.
NOTE:
In some cases the ParkSense graphic will be displayed in
the instrument cluster. In these cases, the gear selector
must be returned to "P" to select desired gear.
If the driver shifts into PARK while moving, the vehicle may

AutoPark.

AutoPark will engage ONLY when vehicle speed is 1.2 mph
(1.9 km/h) or less.
The message "Vehicle Speed Is Too High To Shift To P" will
be displayed in the instrument cluster if vehicle speed is
above 1.2 mph (1.9 km/h).
WARNING!
If vehicle speed is above 1.2 mph (1.9 km/h), the
transmission will default to NEUTRAL until the vehicle
speed drops below 1.2 mph (1.9 km/h). A vehicle left in
the NEUTRAL position can roll. As an added precaution,
always apply the parking brake when exiting the vehicle.
109