Jeep WRANGLER 4Xe 2022 Manual page 31

Hybrid supplement
Table of Contents

Advertisement

T
E
R
S
M
O
NTER
EMOTE
TART
Push and release the Remote Start button on the
key fob twice within five seconds. The vehicle
doors will lock, the turn signals will flash twice
(if enabled in Uconnect Settings), and the horn will
chirp twice (if enabled in Uconnect Settings). Then
the engine/vehicle will start, and the vehicle will
remain in the Remote Start mode for a 15 minute
cycle.
NOTE:
The vehicle can be started two consecutive
times (two 15 minute cycles) using the key fob.
After two remote start events have occurred, the
ignition must be placed in the RUN position
before any additional remote start requests can
be received.
The parking lights will turn on and remain on
during Remote Start mode.
For security, power window operation is
disabled when the vehicle is in the Remote Start
mode.
T
E
R
ODE
O
XIT
EMOTE
W
D
ITHOUT
RIVING
Push and release the Remote Start button one
time or allow the Remote Start cycle to complete
the entire 15 minute cycle.
In addition, the ignition can be placed in the RUN
(Propulsion System Available) position by pushing
the ignition button with the key fob inside the
vehicle, and then pushing the ignition button one
more time to place the ignition in the OFF position.
NOTE:
To avoid unintentional shutdowns, the system will
disable for two seconds after receiving a valid
Remote Start request.
Refer to the Owner's Manual for further
information.
DOORS
H
-D
M
ALF
OOR
I
E
F
QUIPPED
To install the front door exterior mirrors on the
half-doors, proceed as follows:
1. Locate the wiring harness on the outside of
the front half-door.
S
M
TART
ODE
T
V
HE
EHICLE
I
IRROR
NSTALLATION
GETTING TO KNOW YOUR VEHICLE
Wiring Harness Location
2. Insert the wiring harness firmly into the
connection on the driver's side exterior mirror.
Connect Wiring Harness To Exterior Mirror
1 — Wiring Harness
2 — Exterior Mirror
29
2

Advertisement

Table of Contents
loading

Table of Contents