Jeep WRANGLER 4Xe 2022 Manual page 40

38 GETTING TO KNOW YOUR INSTRUMENT PANEL
To reset the oil change indicator, refer to the

following procedure.
NOTE:
This procedure should only be performed after
scheduled maintenance is completed. Resetting
oil life other than when associated with a
scheduled maintenance may result in damage due
to not properly maintaining the engine oil.
1. Without pressing the brake pedal, push the
ENGINE START/STOP button and place the
ignition in the ON/RUN position (do not start
the vehicle.)
2. Push the OK button to enter the instrument
cluster display menu screen.
3. Push and release the down
access the "Vehicle Info" menu screen.
4. Push the left arrow button or right
button to access the "Oil Life" submenu.
5. Hold the OK button to reset the "Oil Life" to
100%.
6. Push the up arrow button to exit the
instrument cluster display menu screen.
Secondary Method For Oil Life Reset Procedure
1. Without pushing the brake pedal, place the
ignition in the ON/RUN position (do not start
the engine).
2. Fully press the accelerator pedal, slowly, three
times within 10 seconds.
3. Without pushing the brake pedal, place the
ignition in the OFF position.
NOTE:
If the indicator message illuminates when you start
the vehicle, the oil change indicator system did not
reset. If necessary, repeat this procedure.
E M
LECTRIC
U
NAVAILABLE
If electric drive mode is unavailable, the reason will
display for five seconds at start up. If your check
engine light comes on, see an authorized dealer
arrow button to
immediately.
arrow
Electric Mode Temporarily Unavailable Message
T
ODE EMPORARILY
See the following information for the most
common reasons that the electric mode would be
unavailable:
Operator Choices that can inhibit Electric Mode -
and what to do about it
Transmission in Manual Shift mode - Shift to

Drive to use Electric mode.
Heavily depressed accelerator pedal position,

requesting high power demand - Beyond the
limits of the electric drivetrain, will cause engine
to run, enabling the powertrain to produce its
full combined power available in Hybrid mode.
Sustained high speed operation in Electric

mode - Using the engine is more efficient for
high speeds than Electric drive.
Transfer case and drive mode selection - eSave

mode almost always runs the engine. Hybrid
mode, in 4WD Low, will also run the engine.
Electric range is depleted - You need to recharge

to enjoy Electric mode, or you can continue
normally in Hybrid.
Hood open (or a hood switch fault) - This is to

prevent unexpected engine starts with the hood
open.