Table of Contents
Advertisement
Electrical Requirements
All electrical wiring must be completed by a qualified
electrician and comply with all local codes and regu-
lations.
Enclose all cables routed in high traffic areas in con-
duit to prevent damage from materials, solvent, and
traffic.
NOTE: All components are electrically tested at the fac-
tory.
The system operates with 89 amps, 60 Hz, 3 Phase,
460 volts input power. All conduits must be installed by a
qualified electrician per U80638 print.
Connect Main Power
1. Connect power to line side of Main Disconnect
Switch (DE).
2. Ground the Main Control Panel to a true earth
ground. See Grounding, page 14.
Connect Main Control Panel to Main
Junction Box
See U80638 schematic.
Connect Main Control Panel to Pumpline
Motors, Agitator Motors, and Heaters
See U80638 conduit schedule and chart.
313813A
Installation
13
Advertisement
Table of Contents
Troubleshooting
