Bringing Up And Configuring Rack 0 - Cisco Router IOS XR Getting Started Manual

Bringing Up and Configuring Rack 0

Interface
---------------- ---- --- --------- -------- ----------------------------
To verify STP information for inter-rack switches, use the show controllers switch inter-rack ports
command, as shown in the following example:
RP/0/RP0/CPU0:router(admin)# show controllers switch inter-rack stp location f0/sc0/cpu0
##### MST
Bridge
Root
Operational
Configured
Interface
---------------- ---- --- --------- -------- ---------------------------
##### MST
Bridge
Root
Interface
---------------- ---- --- --------- -------- ---------------------------
Bringing Up and Configuring Rack 0
When the control network has been established by installing, cabling, and configuring the Catalyst
switches, it is time to bring up and configure Rack 0 in the multishelf system, as described in the
following procedure.
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
Cisco IOS XR Getting Started Guide
3-28
Role Sts Cost
FE_Port_1 Desg FWD
GE_Port_0 Root FWD
0 vlans mapped:
address 5246.48f0.20ff
this switch for the CIST
hello time 1, forward delay
hello time 1, forward delay
Role Sts Cost
1 vlans mapped:
address 5246.48f0.20ff
this switch for MST1
Role Sts Cost
GE_13 Desg FWD
GE_14 Desg FWD
GE_15 Desg FWD
GE_17 Desg FWD
GE_22 Desg FWD
Power down all LCCs and FCCs.
Apply power to the LCC that contains the DSC.
Connect to the DSC console port and log in.
admin
configure
dsc serial serial ID rack 0
dsc serial serial ID rack rackNumber
dsc serial serial ID rack Fn
commit
show running-config | include dsc
Chapter 3 Bringing Up the Cisco IOS XR Software on a Multishelf System
Prio.Nbr Type
200000 128. 2 P2p
20000 128. 49 P2p
2-4094
priority
6, max age
6, max age
Prio.Nbr Type
1
priority
Prio.Nbr Type
20000 128. 14 P2p
20000 128. 15 P2p
20000 128. 16 P2p
20000 128. 18 P2p
20000 128. 23 P2p
32768 (32768 sysid 0)
8, txholdcount 6
8, max hops 4
32769 (32768 sysid 1)
OL-10957-02