Cisco Router IOS XR Getting Started Manual page 35

Chapter 2 Bringing Up the Cisco IOS XR Software on a Standalone Router
Command or Action
Step 3
show redundancy
Example:
RP/0/RP0/CPU0:router# show redundancy
Step 4
show environment
Example:
RP/0/RP0/CPU0:router# show environment
Examples of show Commands
The following sections provide examples of show commands:
•
•
•
•
show version Command
To display basic information about the router configuration, type the show version command in EXEC
mode, as shown in the following example:
RP/0/RP0/CPU0:router# show version
Cisco IOS XR Software, Version 3.3.0[2I]
Copyright (c) 2006 by cisco Systems, Inc.
ROM: System Bootstrap, Version 1.38(20050525:193559) [CRS-1 ROMMON],
CRS-8_P1 uptime is 1 week, 1 day, 17 hours, 1 minute
System image file is "disk0:hfr-os-mbi-3.3.0/mbihfr-rp.vm"
cisco CRS-8/S (7457) processor with 4194304K bytes of memory.
7457 processor at 1197Mhz, Revision 1.2
16 Packet over SONET/SDH network interface(s)
16 SONET/SDH Port controller(s)
2 Ethernet/IEEE 802.3 interface(s)
16 GigabitEthernet/IEEE 802.3 interface(s)
2043k bytes of non-volatile configuration memory.
38079M bytes of hard disk.
1000592k bytes of ATA PCMCIA card at disk 0 (Sector size 512 bytes).
1000640k bytes of ATA PCMCIA card at disk 1 (Sector size 512 bytes).
Package active on node 0/1/SP:
hfr-diags, V 3.3.0[2I], Cisco Systems, at disk0:hfr-diags-3.3.0
hfr-admin, V 3.3.0[2I], Cisco Systems, at disk0:hfr-admin-3.3.0
OL-10957-02
show version Command, page 2-5
show environment Command, page 2-6
show platform Command, page 2-7
show redundancy Command, page 2-8
Built on Mon Mar 13 12:58:02 UTC 2006
By iox8.cisco.com in /auto/ioxws48/production/3.3.0.2I/hfr/workspace for c8
Built on Mon Mar 13 11:46:36 UTC 2006
By iox8.cisco.com in /auto/ioxws48/production/3.3.0.2I/hfr/workspace for c8
Purpose
Displays the state of the primary (active) and standby (inactive)
RPs, including the ability of the standby to take control of the
system.
If both RPs are working correctly, one node displays active
•
role, the Partner node row displays standby role, and the
Standby node row displays Ready.
Displays information about the hardware attributes and status.
Cisco IOS XR Getting Started Guide
Verifying the System After Initial Bring-Up
2-5