Cisco Router IOS XR Getting Started Manual page 36

Verifying the System After Initial Bring-Up
hfr-base, V 3.3.0[2I], Cisco Systems, at disk0:hfr-base-3.3.0
Built on Mon Mar 13 11:43:22 UTC 2006
By iox8.cisco.com in /auto/ioxws48/production/3.3.0.2I/hfr/workspace for c8
hfr-os-mbi, V 3.3.0[2I], Cisco Systems, at disk0:hfr-os-mbi-3.3.0
Built on Mon Mar 13 11:27:02 UTC 2006
By iox8.cisco.com in /auto/ioxws48/production/3.3.0.2I/hfr/workspace for c8
--More--
show environment Command
To display environmental monitor parameters for the system, use the show environment command in
EXEC or administration EXEC mode. The following command syntax is used:
show environment [options]
Enter the show environment ? command to display the command options.
In the following example, temperature information for a Cisco CRS-1 router is shown:
RP/0/RP0/CPU0:router# show environment temperatures
R/S/I
0/1/*
0/6/*
0/RP0/*
0/RP1/*
In the following example, LED status of the nodes in a Cisco CRS-1 router is shown:
RP/0/RP0/CPU0:router# show environment leds
Cisco IOS XR Getting Started Guide
2-6
Modules Inlet
Temperature
(deg C)
host 32, 30
cpu
fabricq0
fabricq1
ingressq
egressq
ingresspse
egresspse
jacket 25
spa0 19
spa5 25
host 32, 26
cpu
fabricq0
fabricq1
ingressq
egressq
ingresspse
egresspse
jacket 24
spa0 19
spa4 22
spa5 24
host 23
host 23
Chapter 2 Bringing Up the Cisco IOS XR Software on a Standalone Router
Exhaust Hotspot
Temperature Temperature
(deg C) (deg C)
26, 27 35
34
27
32
37
32 27
35
29
24 25
25, 32
24
27, 25 33
35
27
32
37
30 25
31
29
25 26
25, 31
33, 35
24
24 24, 33, 26,
24 24, 32, 26,
24, 27
24, 26
OL-10957-02