Navigating the Cisco IOS XR Command Modes
•
Figure 4-5
possible configuration submodes is shown.
Figure 4-5
Administration configuration mode
Logical router configuration submode
Identifying the Command Mode in the CLI Prompt
The command mode is identified in the CLI prompt after the router name.
For example, when the router enters global configuration mode from the EXEC mode, the CLI prompt
changes to include "
RP/0/RP0/CPU0:router# configure
RP/0/RP0/CPU0:router(config)#
When the router enters interface configuration submode, the prompt changes to include "
after the router name:
RP/0/RP0/CPU0:router(config)# interface POS 0/2/0/0
RP/0/RP0/CPU0:router(config-if)#
Cisco IOS XR Getting Started Guide
4-18
Command Mode Navigation Example, page 4-22
illustrates the basic command mode navigation for the CLI. Only a small sample of the
Example of Command Mode Navigation in Cisco IOS XR software
Administration EXEC mode
" after the router name:
(config)
Login
EXEC mode
Global configuration mode
Chapter 4
Configuring General Router Features
Configuration submode
examples
Interface
configuration submode
Router
configuration submode
Line template
configuration submode
Task group
configuration submode
"
(config-if)
OL-10957-02