Creating, Modifying, And Deleting Rules; Creating Rules - Cisco PXM Version 1.1 User Manual

Chapter4 CSR GUI Functionalities

Creating, Modifying, and Deleting Rules

This section describes the steps to create, modify and delete rules.

Creating Rules

Step 1
In the Active Dataset tab in the CSR window, click the down arrow in the Selection box, then select
Rules from the pull-down menu.
Step 2
Click New
The New Rule dialog box appears (
Figure4-35 Dialog Box for New Rule in Active Dataset
The key shown on the screen is the primary key of this rule in the Rules table. When a new rule is being
created, " %%%%" is displayed.
Step 3
In the Name box, enter the name of the rule. The range is 1 to 64 characters.
Step 4
In the Min QoS box, enter the lowest QoS level associated with this rule. The range is 1 to 9.
Step 5
Click the checkbox to the left of Is Default Rule to select this rule as the default rule.
Note
Step 6
In the Rejection Rules (Ingress) area, check the checkbox next to the rule that you want to activate as a
rejection rule as follows:
.
One rule must be made the default rule for the provisioned data to be valid.
Figure4-35 " Dialog Box for New Rule in Active
Cisco Carrier Sensitive Routing User Guide
Updating Active Datasets
Dataset"):
4-35