Updating Active Datasets
Note
Creating, Modifying, and Deleting Match Patterns
This section describes the steps to create, modify, and delete Match Patterns.
Creating Match Patterns
Step 1
In the Active Dataset tab in the CSR window, click the down arrow in the Selection box, then select
Match Patterns from the pull-down menu.
Step 2
Click New
in Active
Figure4-30 Dialog Box for New Pattern in Active Dataset
The Pattern Key on this screen is the primary key of this pattern in the Match Patterns Table. When a
new pattern is being created, "%%%%" is displayed.
Step 3
In the Pattern box, enter the match pattern that a DNIS is to mapped to.
This entry can include 0-9, A-F, *, and period (.).
Step 4
In the Route box, enter the route that applies to this pattern.
Step 5
Click Add to add this pattern, or click Cancel to exit.
Cisco Carrier Sensitive Routing User Guide
4-30
Alternatively, you can delete an attribute by clicking Delete when you are in the dialog box
for modifying the attribute.
.
The following New Pattern dialog box appears
Dataset"):
Chapter4
CSR GUI Functionalities
(Figure4-30 "Dialog Box for New Pattern