Chapter4
CSR GUI Functionalities
Step 4
Click Modify to save the changes, or click Cancel to cancel the changes.
Deleting Contact Lists
Step 1
In the Active Dataset tab in the CSR window, click the down arrow in the Selection box, then select
Contact Lists from the pull-down menu.
Step 2
In the Contact Lists area, click a contact list. You can select more than one list by holding down the Ctrl
key while clicking each contact list.
Step 3
Click Delete
Step 4
Click Yes to delete the contact list, or click No to stop the deletion.
Note
Creating, Modifying, and Deleting Egress Route Attributes
This section describes the steps to create, modify, and delete Egress Route Attributes.
Creating Egress Route Attributes
Step 1
In the Active Dataset tab in the CSR window, click the down arrow in the Selection box, then select
Egress Route Attributes from the pull-down menu.
Step 2
Click New. The following screen appears
Active Dataset
.
A Delete message appears.
Alternatively, you can delete a contact list by clicking Delete when you are in the dialog box
for modifying the list.
"):
(Figure4-25 " Dialog Box for New Egress Route Attribute in
Cisco Carrier Sensitive Routing User Guide
Updating Active Datasets
4-21