Updating Active Datasets
Creating, Modifying, and Deleting Routes
This section describes the steps to create, modify, and delete routes.
Creating Routes
Step 1
In the Active Dataset tab in the CSR window, click the down arrow in the Selection box, then select
Match Patterns from the pull-down menu.
Step 2
Click New
Dataset"):
Figure4-32 Dialog Box for New Route in Active Dataset
The key shown on the screen is the primary key of this route in the Route table. When a new route is
being created, "%%%%" is displayed.
Step 3
In the Name box, enter the name of the route. The range is 1 to 64 characters. This entry is optional.
Step 4
In the Rule box, click the down arrow, then select from the pull-down menu a rule that applies to the
patterns to be used.
Step 5
Click QoS Relationships. The QoS Relationships dialog box appears
Dialog Box in Active
Cisco Carrier Sensitive Routing User Guide
4-32
.
The New Route dialog box appears (
Dataset").
Chapter4
Figure4-32 " Dialog Box for New Route in Active
(Figure4-33 "QoS Relationships
CSR GUI Functionalities