Chapter4
CSR GUI Functionalities
Step 3
From the list, select an Egress Route Attribute by double-clicking on that attribute. Egress Route
Attributes information similar to the following appears (
Route Attribute in Active
Figure4-27 Dialog Box for an Existing Egress Route Attribute in Active Dataset
Step 4
Change the information accordingly.
Step 5
Click Modify to save the changes, or click Cancel to cancel the changes.
Deleting Egress Route Attributes
Step 1
In the Active Dataset tab screen in the CSR window, click the down arrow in the Selection box, then
select Egress Route Attributes from the pull-down menu.
Step 2
Click the down arrow in the Carriers box, then select the appropriate carrier from the pull-down menu.
Step 3
In the Egress Route Attribute list, select an attribute. You can select more than one attribute by holding
down the Ctrl key while clicking each attribute.
Dataset"):
Updating Active Datasets
Figure4-27 " Dialog Box for an Existing Egress
Cisco Carrier Sensitive Routing User Guide
4-25