Chapter4
CSR GUI Functionalities
Note
Creating, Modifying, and Deleting Contacts
This section describes the steps to create, modify, and delete contacts.
Creating Contacts
Step 1
In the Active Dataset tab screen in the CSR window, click the down arrow in the Selection box, then
select Contacts from the pull-down menu.
Step 2
Click New. The following dialog box appears
Dataset"):
Figure4-21 Dialog Box for New Contact in Active Dataset
The contact key is the primary key of this contact in the Contacts table. When a new contact is being
created, " %%%%" is displayed.
Step 3
In the Address Type box, click the down arrow, then select an address type from the pull-down menu.
Step 4
In the RAS Address box, enter address of the contact (IP Address or Gatekeeper ID).
Alternatively, you can delete a carrier by clicking Delete when you are in the dialog box for
modifying the carrier.
(Figure4-21 "Dialog Box for New Contact in Active
Cisco Carrier Sensitive Routing User Guide
Updating Active Datasets
4-17