Negative Film On Glass - Ricoh Aficio Color 4006 Operating Instructions Manual

Selecting the Film Type and Performing Shading

Negative Film on Glass

1
Press the [Shading] key.
2
Insert the "N" (Negative) filter in the left slot as
shown in the illustration.
Note
Be careful to insert the filter as shown, not the other
way around.
3
Cut the positioning sheet to match the film size.
Reference
Regarding the positioning sheet,
4
Place the positioning sheet under the mirror unit
(on the exposure glass).
Note
Place the marked corner of the film position sheet at
the rear left corner of the exposure glass.
Before going to the next step, make sure that the fresnel
lens is lowered in position.
5
Set the base film in the film strip holder.
Regarding setting the base film,
6
Open the film cover and while pressing the holder
lever to the left, insert the film strip holder in the
right slot.
7
Insert the holder until the
shown in the illustration.
190
see page 183.
see page 181.
mark is placed as
1: Filter
1
1. Positioning sheet
1: Holder lever
1
TRSR0F0E
TRSR0G0E
TRSR0Y0E
1
TRSR0J0E