Table of Contents
Advertisement
When copying from custom sized originals, enter the original size so that copy is well aligned.
Limitation
You must set your custom size originals on the exposure glass (platen glass).
Reference
For the standard sizes the machine can detect,
Note
The dimensions you can enter must be within the following ranges:
Vertical size
50 - 297mm (in 1mm steps), 2.0" - 11.7" (in 0.1" steps)
Horizontal size
50 - 432mm (in 1mm steps), 2.0" - 17" (in 0.1" steps)
1
Select the copy paper size.
2
Press the [Custom Size Orig.] key.
3
Make sure that the [Orig. Horiz] key is selected.
Enter the horizontal size with the Number keys,
then press the [#] key.
Note
To change the value entered, press the [Clear] key
and enter a new value.
4
Press the [Orig. Vert] key and enter the vertical
size with the Number keys, then press the [#]
key.
5
Press the [OK] key.
6
Set your original on the exposure glass (platen
glass), then press the Start key.
Setting Custom Sized Originals
see page 28.
[Custom Size Orig.] key
Setting Custom Sized Originals
33
Advertisement
Table of Contents
